Article List

• The Structure Of Hot Melt Coater

  Hot melt coating machine technology and the traditional solvent-based and water-soluble adhesive coating process has an enviable advantage, an effective solution to the traditional process of the inherent shortcomings, is the ideal compound coating industry replacement production tool.Do not use sha

  February 14, 2017
• Clean The Control Of The Pressure Of The Three-point Combination Of Filters

  Clean the inside of the power control box, in the process of cleaning up, please be careful not to loose any wire joints, in order to avoid the phenomenon of short circuit. Check the wire end fittings are secure. As the machine by vibration and repeated heating cooling, will cause the wire connector

  February 14, 2017
• Hot Melt Coater Non-fixed Cycle Cleaning

  Coating method and the glue level to be changed when the hot melt adhesive coating machine to clean the head, cleaning the glue must be solidified before the Tuotou removed, with a dry gauze dipped in 1620 solvent to clean the painted head. During the production process, the equipment should be wipe

  February 14, 2017
• Hot Melt Machine Basic Knowledge

  Hot melt adhesives, hot melt adhesives and related applications hot melt adhesives, hot melt adhesives hot melt machine name in the industry there are many different names actually refer to are hot melt machine, but the name is different, but in the industry The use of the most extensive and standar

  product March 10, 2017
• Hot Melt Adhesive Main Advantages

  Warm-up time is short; hot melt adhesive is solid at room temperature, a heating before becoming liquid; reduce the amount of glue to save the cost; wide range of applications.

  product March 10, 2017
• Common Faults And Countermeasures Are As Follows

  (1) Symptom: Pump can not nestReason: a, the opposite direction of rotation; b, inhalation or discharge valve closed; c, the entrance without material or pressure is too low; d, viscosity is too high, the pump can not biteC, check the valve and pressure gauge; d, check the liquid viscosity, at low s

  product March 10, 2017
• Use Of Hot Melt Adhesive

  The use of hot melt adhesive sprayer, which is a manual spray small machine, only the glue into the drum, the temperature transferred to 100-150 degrees can be used continuously; such machines are generally used in wood, veneer, cardboard , Luggage and other small area occasions. The use of large a

  product March 10, 2017
• Pneumatic Hot Melt Machine Features

  1, light weight, small size, easy to move. Can be placed on the table.2, open cans simple and easy to facilitate the feeding, high security.3, pneumatic power system. Saving energy, effectively reduce the low cost of production.

  product March 10, 2017
• Polyurethane Polyurethane, Including Pressure-sensitive Adhesive And PUR Water-based Plastic Pressure-sensitive Adhesive

  Hot melt adhesive pressure sensitive adhesive, is a pressure-sensitive adhesive, mainly by the synthetic rubber and resin and rubber oil. Mixed into a molten state and then coated in cotton paper, cloth or plastic film and other substrates made of a new type of adhesive tape, low cost is its greates

  product March 10, 2017
• Hot Melt Machine No Glue Detection Troubleshooting

  1. The cylinder does not heatHeater damage (replacement heater)Heater recession (replacement heater)Temperature controller is damaged (replacement temperature controller)Fuse Break Test Lights (Replace Fuse)Temperature sensor line damage (replacement temperature line)The cylinder does not heat, PID

  product March 10, 2017